Drywall Tips & Techniques for Drywall Repair Drywall Tools D
Wall Repair - How To
Ceiling Repair - How To
Drywall Hole Repair - How To
Drywall Patching - How To
Water Damage Repair - How To
Drywall Texture - How To
drywall repairs
drywall repair
drywall repairs

   Installing Drywall, or hanging drywall as the professionals usually refer to the task, can be done by the homeowner. However, it is usually best done with two or more people as it requires significant lifting of heavy material. Mudding and Taping can also be performed by the homeowner, however these tasks require some practice and artistry....More Information
Drywall Repair
Tape and Finish Drywall Like A Pro
By Michael Sakowski



If you are trying to tape and finish drywall for the first time, chances are high that you will do what I and nearly everybody else has done on their first attempt at this art: You will glob on lots of joint compound on the wall thinking that the sand paper will level off the humps and bumps. In the end you end up with a humpy-bumpy wall and drywall dust all over your home!

Sanding is not a good way to level the surface. Rather, you need to use your wide taping knives to level off the just-applied compound and also use your taping knives to level the surface before applying the next coat. Leave the sandpaper alone until the very end!

Here are the basic steps to taping a joint:

1. Place a coat of compound a little wider than the tape. Pass your paper tape quickly through a bucket of water, shake it off, and then place it over the joint. Use a 4" or 4.5" knife to imbed the tape tightly and remove excess compound.

2. After the tape and compound dry, use your taping knife to knock off any chunks or bumps.

3. Place a coat of compound over the top slightly wider than the previous coat. Use your 10" wide taping knife to remove excess mud and leave a level coat.

4. Use your wide knife to "knock down" the surface so there are no bumps or ridges. The knife will make the surface level whereas sanding tends to produce humps and bumps.

5. Repeat steps 3 and 4 several times.

6. Again use your knife to level out the surface. Place small amounts of compound to touch up any depressions, and then finally when all is level, use 240 grit paper on a 3.5" by 8" sanding block to lightly sand.

7. Prime and paint.

For more details on these steps with photos included, go to http://drywallinfo.com .

Michael Sakowski has been doing his own drywall taping and finishing for the last 15 years and through his own experience and consulting with others has developed an easy technique for producing professional quality results. He has created the website http://drywallinfo.com as a step-by-step tutorial for finishing and taping drywall.

drywall tape & finish tips
www.drywallrepairs.info